- Status Closed
- Percent Complete
- Task Type Bug Report
- Category Core
- Operating System Release 1 (Zaxxon)
- Severity High
- Reported Version Hotfix 4
Attached to Project: OpenPandora Main OS
Opened by Paul Brook - 31.08.2010
Last edited by Michael Mrozek - 13.05.2011
Opened by Paul Brook - 31.08.2010
Last edited by Michael Mrozek - 13.05.2011
FS#173 - X uses 100% cpu in low power mode
After 10 minutes in low power mode X seems to go nuts and use 100% CPU. Obviously this is bad ;-) 14MHz isn't *that* slow, so there's obviously something getting wedged.
I haven't been able to figure out exactly what's happening, but the fact that it always occurs after exactly 10 minutes suggests its power management related. Maybe we're getting stuck trying to kick off the screensaver, or something?
Hacking op_power.sh do disable screen blanking shows that, unsurprisingly, the screen freezes at the same time X goes AWOL.
Pressing the power switch brings the device out of low power mode, though there is often a few seconds additional delay as the event handling scripts take longer than normal to run because the CPU is already busy.
I've attached the results of
top -b -d 60 > toplog &
while sleep 60 ; do cat /proc/loadavg; done > loadlog
Closed by Michael Mrozek
13.05.2011 23:45
Reason for closing: Fixed
Additional comments about closing: Should be fixed in HF5.
13.05.2011 23:45
Reason for closing: Fixed
Additional comments about closing: Should be fixed in HF5.